Tag archives for strip-board

Maker-First Steps in Electronics-The rotating and moving plastic container

Rotating and moving plastic container

.   . The rotating and moving plastic container . In previous blog post (tutorial) WE used a vibration motor from an old smartphone and we were learning also about the How-To about a vibration motor is working; it is about “Unbalance“. This unbalance is normally unwanted for motors, but for vibration motors it is […]

Maker-First Steps in Electronics-Building a Power Supply

Prototype Variable Power Supply

. . Building a Variable Power Supply With Few Components In previous tutorial Maker-First Steps in Electronics, the basics WE got a bit the PracTICE of soldering and WE learned ALSO about schematics, resistors, LEDs, diodes and OHM’s Law. WE used ALSO a 9 Volt battery as a power supply for our projects; BUT batteries are expensive (3,99 €) […]

Maker-First Steps in Electronics, the basics

first-steps-on-electronics-fritzing-layout-strip-board

. . Where to start? I propose to work with system when WE use strip-boards; thus meaning: preparing them ALL the same way. Any electronics project will need a power supply, so WE will start with the power supply which will mostly be a 9 Volt battery. WE will use the outside strips to connect […]